To clear timer, press START/STOP/MEMORY button, then press CLEAR button to reset display to zero. To restart same timing period, press START/STOP/MEMORY button once again. To stop timing function before time expires, press correct timer channel button, then press START/STOP/MEMORY button once. TO STOP/RESTART or CLEAR COUNT DOWN TIMERS Flashing channel symbols indicate other timer channels are in operation. Solid channel symbol indicates the count down time of channel being displayed. When using all timer channels, simply press the channel button to note count down time remaining. All 3 timer channels can be used at the same time. Press CLEAR button to reset display to zero.įollow same procedure above for programming the other timer channels. If not turned off, alarm will automatically turn off in 1 minute to extend battery life, however, count up timer continues to operate until START/STOP/MEMORY button is pressed. Press START/STOP/MEMORY button to turn alarm off and stop count up timer. Time1 has 1 repetitive beep, Time2 has 2 repetitive beeps and Time3 has 3 repetitive 2 beeps. Each timing channel has it own distinctive alarm. Clock/Timer Front view of the West Bend timer Overhead view of the both the West Bend Timer and Clock Three quarters overhead view of the West Bend timer. When time expires, alarm will sound and timer will begin to count up in seconds. Time will count down in 1 second intervals. Press START/STOP/MEMORY button to start timer. If error is made in programming, press CLEAR button to zero display, then reprogram time as explained above. The numbers can be fast forwarded by holding individual buttons down for 3 seconds. Press individual HOUR, MINUTE, or SECOND buttons to program desired time. The selected channel symbol will appear in display (T1, T2, or T3). Press Time1, Time2 or Time3 button for desired timer channel. If timers are operating, respective T1, T2 or T3 symbols will flash in display. You can check clock time at any time by simply pressing CLOCK button. Seconds will continue to count in the clock mode. If error is made when programming clock, simply press respective HOUR or MINUTE buttons until correct digits appear. To fast forward minutes, hold button down. Press MINUTE button to advance to correct minutes. Holding down the HOUR button switches between AM/PM modes in 12-hour intervals. The AM or PM indicator will appear in display. Press HOUR button to advance to correct hour. Press CLOCK button down for about 5 seconds until digits flash in display.
0 Comments
Leave a Reply. |